sE Electronics VR2 - Active Ribbon Microphone

sE Electronics VR2 - Active Ribbon Microphone

The VR2, an active ribbon that can take violins and voices right to the foreground of your listener's stereo.

The VR1 and VR2 ribbon microphones mark a new era in ribbon technology. Whereas most ribbon microphones have a dark, muted high-frequency response, the VR1 and VR2 utilize a clever mechanical device to achieve nearly full-range frequency response that extends well beyond that of most other ribbon microphones, approaching nearly 20kHz. This provides an extended level of top end detail, so the result includes not only the distinctly natural low-end and midrange that most ribbons provide, but also minimal loss in high frequency content. Guitar and brass tones retain their “edge”, cymbals still sound rich and full, and a supremely natural sound is achieved from top to bottom.

Additionally, the VR1 and VR2 can handle very high sound pressure levels and thus can be utilized for applications not normally considered for most ribbon microphones, including loud brass, drums, and electric guitar cabinets, both in the studio and on stage.

The VR2 is an active ribbon and requires +48V phantom power for operation. With higher sensitivity than the VR1, it is ideally suited for applications including acoustic instruments, piano, and vocals, as well as the same sources as the VR1 (guitars, drums, brass).

• VR2 microphone
• microphone stand clip
• thread adapter
• wooden case
• shock mount

Specs:

• Electronics: Active
• Generating Element: Hand-tensioned 2.5µm aluminum ribbon
• Directional Pattern: Figure-8
• Frequency range: 20 Hz - 18 kHz
• Impedance: 200 Ohms
• Sensitivity: 10 mV/Pa (-40 dB)
• Max SPL: 135 dB (0.5% THD @ 1kHz)
• Signal to Noise Ratio: 76 dB
• Self Noise: 18 dB(A)
• Matching Connectors: XLR3F
• Power requirement: 48V Phantom
• Weight: 400g / 14.11oz